How to Build a Rocking Chair – Basic Steps to Follow

A rocking chair will help you relax after a hard day’s work. If you want to learn how to build a rocking chair, follow these steps and probably will succeed.

1. First you’ll need to choose the frame type to use for the chair. You can use pine because it is very cheap, or a harder wood such as oak for longer life.
2. Next, cut two pieces of wood, with the following dimensions: 3 / 4 inch thick, 3 1 / 2 inches wide and 21 inches.
3. Then mark 6 1 / 2 inch from the bottom of each of the front legs. Notch the top mark, which is 5 1 / 2 inches long and a depth of 3 / 4 inches. You can use a router for the job.

Complete Plans on How to Build a Rocking Chair Here

4. You can then cut a curve at the bottom and keep the upper right. Use a jigsaw to cut. The upper front support should be 3 / 4 inch thickness, width 5 1 / 2 inches long and 25.
5. You will then need to put glue in the grooves made earlier and place the front support notches higher. Make sure the upper front support and the front legs are square. Secure the front bracket upper screws. Let the glue dry overnight.
6. After the glue has set, screw the bottom front of support within the front legs. This will be of 3 / 4 inch thick, 1 1 / 2 wide and 44 long.
7. The hind legs have to be 3 / 4 inch thick, 3 1 / 2 inches wide and 30 inches. Cut the angles at the top and bottom of the rear legs.
8. Next you will need to form a middle seat support cutting a piece of wood 3 / 4 inch thick, 5 1 / 2 inches wide and 16 inches.
9. Use screws and glue to the back legs on the inside of the front legs. Let the glue dry. Then hold the slats eleven seat on the hind legs that are 3 / 4 inch thick, 1 1 / 2 inches wide and 44 inches long. The strips should be pre-drilled.

Rocking Chair Plans Here!

10. To create a fund to support the back that will need to cut notches at each end of the table. The notches should be 3 / 4 inches thick. Place the top bracket back to 13 to 17 inches of the bottom. Once the glue is dry you can use a jigsaw to cut the top of the shingles on a curve.

11. The arms should be 3 / 4 inch thick, 5 1 / 2 inches wide and 25 inches. But you can decide on the dimensions. Glue the arms of the hind legs, leaving 1 inch extending beyond the front leg.
12. Then, create a lower back support of 3 / 4 inch thick, 3 1 / 2 wide and 44. Angle so that the 20 degrees from vertical. Secure with glue and screws to support the back half.
13. Now build a rocking chair by gluing and screwing rockers two pieces of 3 / 4 inches by 3 1 / 2 by 34 for each rocker. Softening the edges after the glue has dried. Draw the curve of the rocker and then cut. The back curve should be smoother after the bend in front. Paste the rockers to the chair.
14. Use a little varnish to cover the rocker.

Related Blogs

Tags: building a rocking chair, diy rocking chair, how to build a rocking chair, rocking chairs diy

Posted in Woodworking